Blomberg DWT81900FBI Manuel et guide de l'utilisateur télécharger pdf (Page 12)

USA

6.3 ADJUSTING HEIGHT

If the height of the enclosure is 337/8” to 357/8”

(861 mm - 911mm) adjust supports as shown in

the gure.

Supplied (4)

Adjust the front foot level with the adjusting

wrench to balance and raise the dishwasher to the

enclosure height.

Adjust the rear foot level with a screwdriver to

balance and raise the dishwasher to the enclosure

height.

NOTICE :

• Make sure the dishwasher is plumb and

notice dishwasher can be placed with a small

clearance under the counter top.

• Turning the screwdriver in the direction of the

black arrows will bring the dishwasher back feet

up.

• Turning the screwdriver in the direction of the

white arrows will take the dishwasher rear feet

down.

6.4 INSTALLING THE SIDE TRIM STRIPS

Remove the adhesive tape (Figure A).

Place the trim strips on the front edge of the side

walls (Figure B).

NOTICE :

• Make sure you use the correct trim strip since

there is a left and right side strip. The exible

material should be facing forward (Figure B).



1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 26 27

Pas de commentaire

Blomberg DWT81900FBI Manuel et guide de l'utilisateur Page 12